Incised decoration
A type of decoration done on pottery. Designs are carved into the surface of the leather hard ware and often covered by a thickness sensitive glaze.
Details
In pottery and ceramics, incised decoration is carved into leather hard ware. It is often highlighted by cutting through a slip or engobe of contrasting color to the body. Incised decoration can be emphasized or highlighted using a glaze that changes color or crystallizes on the edges of carved contours (where the glaze layer is thinner). Many tools are available for this.
Related Information
Small incised Plainsman H443 bowl
This picture has its own page with more detail, click here to see it.
Incising a stoneware mug
Your browser does not support MP4 video.This is done at the leather hard stage. The lines are in a contrasting color because a black-burning engobe was applied, by dipping, earlier. The clay is Plainsman M340. The tool being used is a Kemper R4 ribbon tool.
Incised decoration (left) vs. slip trailed decoration (right)
This picture has its own page with more detail, click here to see it.
Both are highlighted by Alberta Slip GA6-A glaze on these cone 6 oxidation fired mugs.
Double-slip layer incised decoration: A challenge in slip-body fitting
This picture has its own page with more detail, click here to see it.
An example of a white engobe (L3685T) applied over a red clay body (L3724F), then a red engobe (also L3724F) applied over the white. The incised design reveals the white inter-layer. This is a tricky procedure, you have to make sure the two slips are well fitted to the body (and each other), having a compatible drying shrinkage, firing shrinkage, thermal expansion and quartz inversion behavior. This is much more complex that for glazes, they have no firing shrinkage and drying shrinkage only needs to be low enough for bisque application. Glazes also do not have quartz inversion issues.
M390 mugs with Alberta Slip based glazes by Tony Hansen
This picture has its own page with more detail, click here to see it.
These cone 6 mugs use an 80:20 Alberta Slip:Frit blend inside and out (the outside one has added rutile). Made around 2014. The incised wheat decoration as a dead giveaway that the mug is made by Tony. He has made this type of mug for decades and there is a good reason: continuity of testing. By making the same kind of ware each time he tests a clay, going through the same procedures he has done a thousand times, he can more easily spot differences in the way they perform.
Links
| Glossary |
Slip Trailing
A technique used by potters to decorate ware. Neutral and colored slips, clay in thick paste form, are trailed onto the ware (in raised lines and strokes) to create tactile designs. |